TAP TOLERANCE
CUTTING TAP TOLERANCE RANGE
INTERNAL THREAD TOLERANCE CLASS H H
INTERNAL THREAD TOLERANCE CLASS G G
8G
8H
7G
7H
6G
6H
5G
4G
5H
4H
7GX
7G
6GX
6G
6HX
6H
4H
FORMING TAP TOLERANCE RANGE
INTERNAL THREAD TOLERANCE CLASS H H
INTERNAL THREAD TOLERANCE CLASS G G
8G
8H
7G
7H
6G
6H
5G
4G
5H
4H
7GX
6GX
6HX
4HX
Standard fit for a thread corresponds to tolerance class ISO 2/6H. For more precise fits, without allowance on thread flank, tolerance class ISO 1/4H must be chosen. ISO 3/6G is used in case of loose fits, with large allowance, which is often required for subsequent coatings. Between classes 6H and 6G, as well as between classes 6G and 7G, tap manufacturers produce taps with tolerance 6HX and 6GX. These taps are used for tapping abrasive materials, such as cast iron or Al-Si alloys, in order to increase their tool life. Another important application is on forming taps, which create the thread by plastic deformation and not by cutting. In this case, due to the elastic return of the material, in order to obtain a thread 6H tolerance, a 6HX tap must be used.
The tolerances described above are collected in the European standard EN 22857.
268
Made with FlippingBook - Online Brochure Maker