GPC-D20-00 Page 9 of 19
Manufacturer System
Power Phase
Amps
Neutral Required Connection Type
GE
DIQ 3 Ring
480 3 Phase 480 3 Phase 480 3 Phase
150 No 150 No 150 No
4-Wire w/Ground Wye 4-Wire w/Ground Wye 4-Wire w/Ground Wye
Parc 4 MIDR
Configuration The connector is wired for three phase, five wire, Wye connection, with ground/neutral dependent on system (not less than AWG #1/0). Load Regulation at Line Frequency Wires are to be sized such that the line voltage drops from the power source to the mobile unit is less than 2.5% of the nominal voltage for the rated load of the mobile unit. Frequency 60Hz ±2.0Hz. Phase Balance The phase balance is 3% maximum of lowest phase-to-phase voltage. Maximum Voltage Variation The maximum voltage variation is +11% / -4% from a nominal steady state (under the worst case conditions of line voltage). Connector Type The mobile unit is supplied with a 50’-0” power cable and male conductor. Unless otherwise specified, the connector type is a Russellstoll DS2504MP000/ DF2504FRAB0 480V 200A rated plug. Customer Facility The customer facility must have the matching receptacle as specified in Figure 6: Russellstoll Receptacle, Service Disconnect and Figure 7: Russellstoll Receptacle Chart . Unless otherwise specified, the receptacle type to be used must be a Russellstoll DF2504FRAB0 female connector. Input Power • Frequency: 60Hz ±2.0Hz • Regulation: Load regulation must not exceed 2.5%. • Phase Imbalance: The difference between the highest line-to-line voltage and lowest line-to-line voltage must not exceed 3% of the lowest line-to-line voltage.
The information contained in this booklet is the property of AMST. The contents are confidential. They may not be used, either partially or wholly, for any purpose inconsistent with the purpose for which it was produced. The contents may not be reproduced or disclosed without written permission of AMST.
Made with FlippingBook. PDF to flipbook with ease