Radio I will start with an article by AR Almond, which appeared in March 1947, entitled Carrier frequency wire broadcasting, based on work which had been taking place in the mid-30s, had been interrupted during the Second World War and was then being resumed. It describes the application of carrier frequencies to augment the capacity of audio distribution networks which had existed since before the war. These required a pair of wire for each programme and, as radio broadcasting expanded, this meant upgrading the networks. The article proposes therefore that radio frequencies be used to stack a number of programmes on each pair of wires. A system comprising four carriers, separated by 20kHz in the band 200-300kHz is described. It is an example of a good idea that was somewhat ahead of its time. It did not succeed commercially because it required in-home equipment to amplify and detect the signals. It must be remembered that the networks owed their existence to the fact that radio reception in those early days was not easy. Radio receivers contained valves, which needed to be heated, grid biased and HT powered. Since many houses were not connected to a domestic electricity supply, early radio receivers were battery powered, including an accumulator for the heaters. This had to be regularly taken to the local garage for recharging: in today’s parlance, not a user- friendly service. Networks which delivered audio directly into a loudspeaker were therefore extremely popular and successful, meeting that most important criterion: customers’ needs.
Television The existence of these audio networks was to prove an immense incentive to inventive people to come up with schemes for using them to distribute television. It is not surprising therefore to see an article, on exactly such a proposal, appear in September 1952, entitled Television
highlight the intense activity that was underway in two of the companies involved in the Industry.
Previously, achieving good picture quality was a matter of ensuring a flat frequency and a linear phase response. These measurements have never been easy to perform on networks. The pulse and bar testing technique is ideally suited to field measurements and has become universally accepted by the world standardisation bodies as the method to be used for picture quality evaluation on CATV networks. The article contains some original work on the visibility and K rating of long delay echoes as well as a thorough description of the application of transversal equalisers to correct pulse distortions. It is noticeable how in all these early articles cable television, as we know it now, was invariably referred to as ‘television relay’. The Industry from its early days was shackled by regulations from successive governments which forbade anything other than a broadcast relay operation. Pay television Continuous pressure and lobbying by the industry bodies gradually brought about some relaxation and in 1964 a limited number of trials of Pay TV schemes was allowed. These early experiments were reported in the Proceedings of the Society Vol.VI No.4 March 1964. Audience measuring systems and anti-piracy considerations are all given thorough consideration. Once again, the technology was available but the heavy hand of government regulation made it impossible to exploit its potential. Consequently, the trials were rather short-lived as they were not followed by the necessary deregulation until some 20 years later.
It is interesting to note that between them, these two companies eventually operated networks connecting a total of well over one million subscribers with percentage penetration rates in the mid-50s. It is also interesting to note that these very successful systems all operated in the frequency band 4-10MHz. This required that special receivers be used. They were, in fact, very simple TRF designs, thereby greatly enhancing their reliability. They were made and rented by the cable operators in very large numbers and can be considered, not just as the first ‘cable ready’ but in fact the first ‘cable only’ receivers. Picture quality The UK has always prided itself on the quality of its television broadcast service, not only in programme content but also in terms of the picture quality delivered to the customer. It was essential therefore, if cable television was to succeed in areas other than those with poor reception conditions, that the picture quality delivered to subscribers should be of the highest possible standard. The UK Cable TV Industry was therefore a pioneer in the application of picture quality testing techniques to its networks. An article by BW Osborne, entitled Picture quality control equipment for wired television, which appeared in March 1961, typifies the efforts that were being made by cable operators to ensure that their networks delivered the best possible signal quality. In the article, the original work of Lewis and Macdiarmid is acknowledged, and the use of the sine squared pulse for K rating assessment is described.
Early 1948 copy of Proceedings of the Society
relay by wire in which Eric Gargini, then working for EMI, describes a cable distribution system using HF carriers on balanced twisted pair feeder networks. It contains the first published account of the use of subscriber taps to make the subscriber loading negligible with respect to the cable loss and thus avoid the need for complete planning of the network. The exact words are “the relay company, not knowing exactly how many subscribers to cater for, would not want an inflexible system, a system requiring planning of signal levels to every point” and “as subscribers came on the system, their connection would not disturb the signal level at the far points of the system by more than 2dB – a negligible amount”. The following years proved to be very prolific and articles such as Distribution of television by wire by RI Kinross of Rediffusion in May 1957 and Television relay with particular reference to the BRW Mark II television relay equipment by KA Russell of British Relay Wireless in September 1958,
42
75 Plus - A history of the SCTE, The Society for Broadband Professionals
75 Plus - A history of the SCTE, The Society for Broadband Professionals
43
Made with FlippingBook - Online magazine maker