INDEX
Assembly Devices
Assembly Devices
Hinge & Aventos Assembly Devices
CABLOXX Assembly Devices
CABINET ANGLE TEMPLATE
CUTTING-TO-SIZE TEMPLATE CABLOXX
• •
Template for determining the cabinet angle Determining the correct hinge solution
• Template for cutting the locking bar, spacers and synchronisation linkage to size • Template for pre-drilling or drilling end cap and attachment for synchronisation • Template for cutting the synchronisation linkages (TIP-ON BLUMOTION and side stabiliser) to size
Assembly Possibilities
Place locking bar template and drill Ø 5mm hole for attaching the end cap in the locking bar. Position template in cabinet and pre-drill 2.5mm hole for syncronisation section.
Cut spacer to desired size using supplied flat chisel and hammer
Cut locking bar and synchronisation linkage to the desired size using saw
Position template on angled cabinet Note cabinet angle and angled application
A suitable hinge solution depends on the cabinet angle or angled application
Number refers to applicable hinge. See Section B for specific selection
Description
Blum No
Code
Cutting-to-size Template
65.0801
1-285-730
LEGRABOX MARKING TEMPLATE FOR CABLOXX FRONT LOCKING BRACKET
Description
Material
Blum No 65.5810.02
Code
Cabinet Angle Template
Nylon
1-335-508
• Template for marking height position for CABLOXX front locking bracket • Material: Nylon
DRILLING TEMPLATE FOR AVENTOS SERVO-DRIVE SWITCH
Assembly Possibilities
• Simple hand-held tool for drilling accurate holes for the SERVO-DRIVE switch attachment • Driven by hand drill • Drilling template can be used with assembled and unassembled cabinets • Assembly on a marking line
- Adjust drawer side height - Clip template on to the attached front fixing - Mark fixing position for front locking bracket - Drill holes using a drilling machine
Hinge system assembly
Description
Blum No
Code
- Mark desired SERVO-DRIVE switch position - Position template on marking line and fix with clamping screw - Perform attachment drillings for the SERVO-DRIVE switch with the hand drill
for LEGRABOX
65.0807
1-285-725
TANDEMBOX MARKING TEMPLATE FOR CABLOXX FRONT LOCKING BRACKET
• Template for marking height position for CABLOXX front locking bracket • Material: Nylon
Assembly Possibilities
- Clip template on to the attached front fixing - Mark fixing position for front locking bracket - Drill holes using a drilling machine
Description
Material
Blum No
Code
Drilling Template For AVENTOS SERVO-DRIVE Switch
Aluminium Die Casting
M31.2000
1-285-705
Composed of: 1 x Drilling template for SERVO-DRIVE switch 1 x Fittings drill bit Ø 35mm 2 x TORX bit
Description
Blum No
Code
for TANDEMBOX
65.0803
1-285-720
CONTENTS
E.20
E.21
LIFT-SYSTEMS & ASSEMBLY DEVICES
LIFT-SYSTEMS & ASSEMBLY DEVICES
Dimension data and specifications may change without notification.
LINCOLN SENTRY
Made with FlippingBook Learn more on our blog