Halton Brochure

Installation on the ceiling in combination with hoods or ventilated ceilings LFU - LAMINAR FLOW UNITS

Overview:

Halton laminar flow units are designed for a combination use with hoods or ventilated ceilings in high energy commercial kitchens and show kitchens. Halton LFU laminar flow units are a well-designed make up air strategy that guarantees the effciency alongside the fnal Indoor Air Quality (IAQ) inside the kitchen. They are designed to break the speed of the fresh air carried by the supply ductwork, distribute it equally inside the units and laminarise the flow.

Features:

• Compliant design: Halton Laminar Flow units comply with any integration requirements, with possibilities of customisation. • Efficient: UL1046 Classifed Cyclonic flters are permitted for Flame and spark arrestance. Contributes to saving energy compared to traditional diffusers by contributing to exhaust airflow rates reduction of the hoods and ventilated ceilings. • Effective: Halton Laminar Flow units contribute directly to good working conditions and productivity improvement by improving indoor air quality and the percieved temperature. • Healthy: Specifc design of the dampers and the association of a honeycomb structure to the perforated front face “laminarise” the air flow, resulting in a continuous flow of fresh air. • Easy: Halton Laminar flow units are easy to install with a wide range to match any integration units, and standard dimensions to ft false ceilings with a 600x600mm grid. Also designed to facilitate easy cleaning. • Make-Up air: The unit’s makeup air strategy contributes not only to guarantee this effciency but also to the fnal Indoor Air Quality (IAQ) inside the kitchen.

LFU units combined with hoods:

LFU units combined with a ventilated ceiling:

Laminar flow supply Better smoke capture and comfort

Typical Section & Plan of the standard units with vertical connections (Recommended):

REAR ENTRY

TOP ENTRY

Ceiling

Ceiling

SECTION A-A

SECTION A-A

ALLIED MEMBER

ALLIED MEMBER

R

R

Kitchen Exhaust Hood shall comply with the requirements or NCC 2015 and AS1668.2 2012. Constructed from 1.2 mm AISI 304 Satin fnish with fully welded exhaust plenum. The hood shall be supplied complete with vertical and horizontal Capture Jet™ technology, high effciency UL1046 Certifed Cyclonic Filters (KSA) and pressure measurement points, exhaust and supply air adjustment dampers, and flush fluorescent light fttings with installation hatch to provide minimum 500 lux at the cooking surface. The size shall be as indicated in the drawings. The hood will be designed to save energy and capture effciency will be calculated using convective heat calculations methods. Make-up air will be supplied at low velocity through the front face of the canopy.

30

Made with FlippingBook - Online Brochure Maker