33 D
ESI-309A
ESI-192
LIS-32900
MTI-FF310
ESI-195
LIS-60150
ESI-193
CIRCUIT TESTERS
ESI-192
$91.09
Relay Buddy® 12/24 (Tester only)
Settable to 4 and 5 pin relay. Three diagnostic trouble codes. #192 includes the Relay Buddy and a zippered case.
ATD-5624
#193 includes (5) relay adapters, (3) adapters for testing shielded relays and (2) adapters for testing new relay types commonly used on fuel pumps and other powered devices. It applies a 7+ amp load to the relay and looks for excessive voltage drop. Test results are displayed by the green, yellow or red LED. #195 can test 10 different 12V relays. Includes three adapters for shielded relays. Large backlit LCD display for visible voltage readings. Checks electrical circuits on all 3–48 volt vehicle systems. Impedance Rating: 200–4000 Ohms. 12 ft. coiled test lead. Ready for use in the new generation of vehicles with mixed or single 24V systems. Internally protected against power surges and overloads. 8” flexible probe reaches wires in congested places. LEDs show open or short circuit conditions. Trace wires inside bindles, conduits, behind panels, under carpets, upholstery, etc. Tests 6 and 12V systems. Locates shorts, open circuits and grounds. Use with ignition on. Clip to ground anywhere on vehicle and use probe to make contact with wire or cable being tested. Bulb indicates condition of circuit. Tests circuits from 3 to 28 Volts DC. LED light and buzzer indicator. Does not require a ground wire or clip. Safe for work on automo- tive computers, ECMs, airbags, etc. Special V-tip allows safe piercing and can be removed to test hard-to-reach places. Operates on replaceable long-life “N” or “LR-1” size alkaline batteries (included). Easily checks 6 and 12V systems. 5 ft. heavy-duty lead. Tough plastic handle lights up if circuit is good. Lead remains flexible in low temperatures. New coil cord design for ease of use. Acetate handle, coiled lead wire. Easily checks 6 and 12V systems. New full size comfortable acetate handle lights up when circuit is good. Leads remain flexible in low temperatures. Ground lead stretches up to 10 ft. Heavy-duty circuit tester for checking low voltage up to 12 volts. By depressing the red button the tester becomes a jumper for powering electrical components or a ground. The probe, handle, cord and clamp are reinforced for durability. Comes with a strain relief spring on the cord. 3–30V detection range of DC voltage. Bi-directional polarity testing: Power and Ground. Dual color LED indicates red for power and green for ground on 6V, 12V and 24V systems. Compact size for use in tight access areas. Computer safe. For use on automo- tive, commercial vehicle and equipment repair. For use on 12V & 42V Hybrid systems. Automatic Voltage Identification: BLUE LED for 12V and RED LED for 42V. Pointed probe tests through wire insulation. Computer and airbag safe. 12 ft. heat and oil resistant coiled cord.
ESI-193
$198.69
ATD-5513
Relay Buddy® Pro Test Kit
ESI-195
$221.95
Super Relay Buddy® Pro Test Kit
ATD-5503
3–48 Volt LCD Wide Range Digital Circuit Tester
ATD-55045
$36.59
FaultFinder Short/Open Circuit Finder & Circuit Tracer
MTI-FF310
$196.69
Primary Circuit Tester with Ground Clip Cordless Professional Circuit Tester 3–28V
ATD-5500
$10.99
ATD-5500
ATD-5503
$21.69
ATD-55033
ATD-55042
ATD-5513
$14.99
Heavy-Duty Circuit Tester
Heavy-Duty Circuit Tester with Coiled Lead Wire
ATD-5624
$16.29
LIS-32900
$24.69
Heavy-Duty Circuit Tester/Jumper
ATD-55045
Heavy-Duty Cordless Circuit Tester 3–30V
ATD-55033
$50.39
ATD-55042
$26.79
12–42V Hybrid Circuit Tester
FUEL SYSTEM TESTING
200-1145 Pressurized Induction Tool Features: • Helps you perform an effective induction service on direct or conventional fuel injected engines • Chemicals NOT included with tool and must be purchased separately Visit www.motorvac.com for more information PRESSURIZED INDUCTION TOOL KIT
MASTER FUEL INJECTION PRESSURE TEST KIT
MASTER GLOBAL FUEL INJECTION PRESSURE TEST KIT Covers all major model platforms, domestic and foreign, 1988 to present. Redesigned fuel line tee accommodates 3/8”,1/4” and 5/16” hose sizes. A longer tee adapter to cut test hoses for easier connections. Molded storage case. Gauge assembly disconnects from test hose and valve assembly for easier storage and improved gauge protection. ATD-5650......................$412.89
$527.59 ATD-5578
Tests both foreign and domestic fuel injection systems; includes late model GM, Chrysler and European applications; large 3-1/2” gauge with dual reading of 0–145 psi and 0–1000 kPa; allows checking for sufficient fuel flow; low pressure 2-1/2” gauge
MOV-200-1145.......... $439.95
NOID LIGHT SET • Includes (10) noid lights plus 4 ft. extension for easy viewing • Quickly and easily tests electronic fuel injection systems on: • GM TBI • GM ‘87 - present • GM ‘82-’91 • Bosch PFI • Ford TBI • GM PFI • Geo TBI • GM SCPI BASIC FUEL INJECTION PRESSURE TESTER
FUEL INJECTION CANISTER CLEANER
DELUXE VACUUM/ FUEL PUMP TEST KIT 2 ft. of high quality hose, (3) fittings to test domestic and foreign cars and trucks with gas engines; hook- on 3-1/2” compound gauge has a multi-color dual scale dial with rang- es from 0–10 psi, 0–0.7kg/cm 2 and 0–28inHg/0–70cmHg vacuum
Centrally mounted chain and S-hook provide better balance during cleaning process; stain- less steel braided Teflon ® hose; reduces potential damage by separating the gauges and manifold from the canister during filling; will restore the orig- inal spray pattern, giving improved performance, fuel economy and emissions test.
ATD-5612..........$55.69
Tests most systems except Bosch CIS and GM TBI; 2-1/2” dual scale gauge reads 0–100 psi or 0–7 BAR; includes the necessary adapters, banjo bolts, and 16” gauge hose with quick coupler and adapter guide book ATD-5633........................ $185.09
ATD-5657.................................................... $37.89
MTI-TU470B................$273.59
FUEL INJECTION PRESSURE TESTER WITH SCHRADER ADAPTERS
3 WAY EXHAUST BACK PRESSURE KIT
• Test oxygen sensor, exhaust pipes and injection system • Gauge has (2) multi-colored bands; idle and 2500 rpm, with pressure shown in psi and BAR • 6 ft. hose
Tests all cars with standard or small Schrader valves; 3-1/2” gauge has a dual scale dial with ranges from 0–100 psi and 0–7 BAR; quick coupler connection at end of gauge hose
FUEL INJECTION PRESSURE TESTER Tests American Motors, Bosch, AFC, MPC European and Japanese (except CIS); basic fuel injection tester includes large and small Schrader adapters; M6-1.00 O-ring adapter and tee manifold Chrysler, Ford, GM (except TBI); Japanese and Bendix-type systems; 2-1/2” gauge has dual scale with ranges from 0–100 psi and 0–7 BAR
MTI-TU469........... $148.59
MTI-TU24APB.............. $132.79
ATD-5567..................................................... $58.29
Made with FlippingBook flipbook maker