Land Development Ordinance - Amended 11-19-2024

iii. Painted or stained concrete (including concrete block without architectural surface)

iv. Corrugated or single-skin metal siding

v. Plastic

vi. Stucco or EIFS (Exterior Installation Finishing System) [except that a maximum of 20% of a single building façade wall may be permitted for accent, trim or architectural features]

vii. Exposed fasteners on any primary building material

(3) Roofs for All Nonresidential Buildings & Structures . The following standards shall apply for roofs and roof structures:

A. Roof Pitch . Roof pitches less than 3 by 12 and flat roofs shall require a parapet wall, except as otherwise provided in the Land Development Ordinance.

B. Parapet Wall . If a parapet wall is proposed the parapet wall shall extend around the entire building roof and shall be finished to match the front, side and rear façades on all buildings except for in the following conditions:

i. The rear façade parapet shall not be required if the rear of the building is not facing a public right-of-way or a residentially zoned property;

ii. In the Industrial districts, the parapet is only required on the sections of the façade required to meet the primary building façade standards.

C. Top of Parapet . The top of the parapet wall shall have a coping and/or a cornice along the face of the parapet at the top.

(4) Material Changes . Materials may change horizontally at any location, but primary building materials along the plane of a building wall shall change vertically only at interior corners.

Made with FlippingBook interactive PDF creator