Workshop
Tag-Z Pro 180 0 Wheel Balancer Kit
This wheel Balancer has be made for top wheel builders and home DIY. It has been designed to work 3 different ways to make wheel building easier and faster, as you can lay the balancer at 90 0 . You can tighten the spoke nipples faster and easier, then when coming to the final stage of torquing the nipples you can rotate it back. The wheel balancer comes with a magnetic base dial stand so you can move it about easy as it has a magnetic base and the wheel balancer has been made from steel, the dial indicator gauge fixes to the magnetic base for a clean reading, so you can balance your wheel to 0.01mm The stand comes with a stainless steel 12mm pin and 2 alloy cones to suit wheel bearings from 14-29mm. Please make sure that the wheel bearings
are in good condition before balancing a wheel. Once you have finished using the wheel balancer, you can flat pack it to save room in you workshop. Comes with wing nuts for fast removal. Constructed from high quality heavy duty steel with a powder coated finish. Available in 2 different high quality powder coated finishes: Blue or Red. Wheel Balancer Stand #33-532
Tag-Z Wheel Balancer Stand
TAG-Z Wheel Balancer Stand, for the truing of your wheel. Stand comes complete with axle pin and alloy tapered cone stoppers. Cone stoppers can be used with wheels with an inside wheel bearing diameter of 14 to 30mm. Constructed from high quality heavy duty steel with a powder coated finish. Available in 2 different high quality powder coated finishes: Blue or Red. Wheel Balancer Stand #33-530
Tag-Z Shaft With Cone Stoppers Wheel support 12mm x 420mm stainless steel shaft with 2 alloy cone stoppers. Cone stoppers can be used with wheels with an inside bearing diameter of 14 to 30mm. 12mm Shaft With Cone Stoppers #33-531
33-531
All Orders: Tel: 01597 822 666 Fax: 01597 825 224
16
Made with FlippingBook - Online catalogs