Brake AB 44 24 VDC, 2.5 Nm
Important information • Permanent magnet – single-face brake for DC (dry operation). Braking in unpowered condition. • Holding brake, prevents rotation of the shaft at standstill or with turned off motor power. • Not suitable for dynamic braking. • It is possible to lower the voltage applied to the brake after it has been energized, for the purpose of reducing heat loss. • Protection: IP54
Stock program Standard program Special program (on request)
Part numbers
386052 385999 386054 386000
Cable output axial Cable output radial
Type
overall length
overall length
Modular system + Motor
Page + Gearhead
+ Sensor
Page
Page
Overall length [mm] / • see Gearhead
RE 50, 200 W 291 RE 50, 200 W 291 RE 50, 200 W 291 GP 52, 4 - 30 Nm RE 50, 200 W 291 GP 52, 4 - 30 Nm
170.4 183.4 •
386-387
HEDL 9140 434
386-387 HEDL 9140 434
•
RE 65, 250 W 292 RE 65, 250 W 292
187.5 205.5
HEDL 9140 434
Technical data Holding torque Mass inertia Max. speed
Pin allocation
24 VDC ±10% Cable (AWG 18) R20 = 64 Ω ±7% white
Designation Motor+
2.5 Nm Nominal voltage, smoothed
90 gcm2 Resistance 10 000 rpm Duty cycle
100% brown ≤ 20 ms green ≤ 35 ms yellow
Motor-
Weight
0.19 kg Reaction time
– Coupling – Opening
U Brake + 24 VDC U Brake GND
-40…+100°C
Ambient temperature range
Min. cable length
1490 mm
480 maxon
© 2026 maxon. All rights reserved. April edition. Subject to change.
Made with FlippingBook Publishing Software