Screw Drive Options
Option
to GP 16 S
to GP 22 S
Without specification, the screw is supplied in the standard length 102 mm. Special lengths can be ordered in 5 mm steps up to the stated maximum length.
Without specification, the screw is supplied in the standard length 151 mm. Special lengths can be ordered in 5 mm steps up to the stated maximum length.
Special length Reference FLEX-GEAR-SPIN02/03
FLEX-GEAR-SPIN04/05
Configurable length
Configurable length
Screw end Reference FLEX-GEAR-SPIN06 In order to support the end of the screw by an additional bearing, it can be delivered according to the illustration. Customer specific screw ends on request.
5
4
18 * 1 20 * 2
60°
60°
4 x Ø2.9
3.5
4 x Ø3.4
Flange nut Reference FLEX-GEAR-SPIN08 Flange nut instead of the standard thread nut. If using a ball screw, the rectangular mounting flange (FLEX-GEAR- SPIN10) must be used.
16
4
16
Ø18
Ø18
18
* 1 Kugelumlaufspindel / Ball screw * 2 Metrische Spindel / Metric lead screw
Axial play is almost eliminated through increased preloading of the ball screw nut. Although, the increased load can lead to greater wear.
Low backlash ball screw nut Reference FLEX-GEAR-SPIN09
Not available for GP 16 S.
Rectangular mounting flange Reference FLEX-GEAR-SPIN10 Screw drive with rectangular moun- ting flange allows mounting from the gearhead side. If using a ball screw with flange nut, the rectangular assembly flange must be used for mounting.
On request.
488 maxon screw drive
© 2024 maxon. All rights reserved. September edition. Subject to change.
Made with FlippingBook Publishing Software