Screw Drive Options
Option
to GP 32 S
Without specification, the screw is supplied in the standard length 200.8 mm. Special lengths can be ordered in 5 mm steps up to the stated maximum length.
Special length Reference FLEX-GEAR-SPIN02/03
FLEX-GEAR-SPIN04/05
Configurable length
Screw end Reference FLEX-GEAR-SPIN06 In order to support the end of the screw by an additional bearing, it can be delivered according to the illustration. Customer specific screw ends on request.
10
60°
4 x Ø4.5
Flange nut Reference FLEX-GEAR-SPIN08 Flange nut instead of the standard thread nut. If using a ball screw, the rectangular mounting flange (FLEX-GEAR- SPIN10) must be used.
5
22
Ø27
28
Axial play is almost eliminated through increased preloading of the ball screw nut. Although, the increased load can lead to greater wear.
Low backlash ball screw nut Reference FLEX-GEAR-SPIN09
Rectangular mounting flange Reference FLEX-GEAR-SPIN10 Screw drive with rectangular moun- ting flange allows mounting from the gearhead side. If using a ball screw with flange nut, the rectangular assembly flange must be used for mounting.
maxon screw drive 489
© 2024 maxon. All rights reserved. September edition. Subject to change.
Made with FlippingBook Publishing Software