maxon Product Range 2025/26

ENX 13 GAMA Encoder ∅ 13 mm, 16 CPT Radiation-resistant

Key data

GAMA incremental

Number of channels Counts per turn Encoder length L1 Ambient temperature

2 16 7.0…9.0 –20…+105 <5

mm °C

Weight

g

Selection criteria

GAMA incremental

Speed and rotation direction detection Speed and position control Compact and robust design

High resolution Cost effective

suitable

suitable to a limited extent

not suitable

Specifications Supply voltage V CC Typical current draw Max. operating frequency

GAMA incremental

GAMA Radiation resistance

V

5 ±0.5 9.5 24 60 000

The GAMA encoder type is resistant to ionizing radiation Tested with a Co60 radiation source (gamma radiation) at up to 18 krad/h and a maximum radiation dose (TID) of 500 krad.

mA kHz rpm

Max. Speed Connector

10-pin 2.54 mm multipoint connector (IEC/EN 60603-13 / DIN41651) Pin 1 Motor + Pin 2 V CC

Pin 3 channel A Pin 4 channel B Pin 5 GND Pin 6 Motor –

Pin 7 not connected Pin 8 not connected Pin 9 not connected Pin 10 not connected Output signal: TTL compatible, push-pull Output current per channel: ±10 mA

Configurations Connector Cable length

50, 100, 150, 200, 300, 500 GAMA incremental 6-pin, 10-pin

mm

DC motor DC-max 16 S DC-max 22 S DC-max 26 S Modular system

Page Dimensions standard version

M 1:1 Notes

1 The length shown here refers only to the encoder. The additional length when mounted on a motor, or the effective length of a motor/encoder combination, can be found on the respective dimensional drawing. Maximum permissible cable/plug continuous current: 1.2 A. Ordering information: For motors that cannot be configured online, use the part number 714445 when ordering the ENX 13 GAMA.

121–122 123–124 125–126 135–150 151–155 171–174 175–178 179–182 183–186

RE 13 RE 16

A-max 16  A-max 19 A-max 22 A-max 26

Further technical details can be found in the product information in the online shop under Downloads.



498 maxon sensor 

© 2025 maxon. All rights reserved. February edition. Subject to change.

Made with FlippingBook Publishing Software