ENX 10 GAMA Encoder ∅ 10 mm, 12 CPT Radiation-resistant
Key data
GAMA incremental
Number of channels Counts per turn 1 Encoder length L2 Ambient temperature
2 12 8.0 –20 +105 <5
mm °C
Weight
g
Selection criteria
GAMA incremental
Speed and rotation direction detection Speed and position control Compact and robust design
High resolution Cost effective
suitable
suitable to a limited extent
not suitable
Specifications Supply voltage Vcc Typical current draw Max. operating frequency
GAMA incremental
GAMA Radiation resistance
V
5 ±0.5 9.5 24 60 000
The GAMA encoder type is resistant to ionizing radiation Tested with a Co60 radiation source (gamma radiation) at up to 18 krad/h and a maximum radiation dose (TID) of 500 krad.
mA kHz rpm
Max. Speed Connector
10-pin 2.54 mm multipoint connector (IEC/EN 60603-13 / DIN41651) Pin 1 Motor + Pin 2 V CC
Pin 3 channel A Pin 4 channel B Pin 5 GND Pin 6 Motor –
Pin 7 not connected Pin 8 not connected Pin 9 not connected Pin 10 not connected Output signal: TTL compatible, push-pull Output current per channel: ±10 mA
Configurations Connector Cable length
50, 100, 150, 200, 300, 500 GAMA incremental 6-pin, 10-pin
mm
maxon modular system
Page Dimensions standard version
M 1:1 Notes
DC motor RE 10, 0.75 W RE 10, 1.5 W
1 maxon controllers require a resolution of at least 16 counts per turn. 2 The length shown here refers only to the encoder. The additional length when mounted on a motor, or the effective length of a motor/encoder combination, can be found on the respective dimensional drawing. Maximum permissible cable/plug continuous current: 1.2 A. Ordering information: For motors that cannot be configured online, use the part number 714457 when ordering the ENX 10 GAMA.
130 132
Further technical details can be found in the product information in the online shop under Downloads.
maxon sensor 501
© 2024 maxon. All rights reserved. August edition. Subject to change.
Made with FlippingBook Publishing Software