ENX 8 EASY INT Encoder ∅ 8 mm, 1…1024 CPT Integrated into motor
Key data
EASY incremental differential
EASY incremental, commutation signal
Number of channels Max. counts per turn Encoder length L Ambient temperature 2
3
3
1024
1024
mm 0 (integrated into motor)
-20…+100 (-40…+100) 0 (integrated into motor)
°C
-20…+100 (-40…+100)
Weight
g
<4
<4
Selection criteria
EASY incremental differential
EASY incremental, commutation signal
Speed and rotation direction detection Speed and position control Compact and robust design
High resolution Cost effective
suitable
suitable to a limited extent
not suitable
Specifications Supply voltage Vcc Typical current draw Max. operating frequency
EASY incremental differential
EASY incremental, commutation signal
V
5 ±0.5
5 ±0.5
mA kHz rpm
17
17
500
500
Max. Speed 5 Connector³
30 000 – 80 000
30 000 – 80 000
10-pin 1.27 mm multipoint connector e.g. Samtec FFSD series Pin 1 do not connect 4 (BiSS-C Data) Pin 2 V CC Pin 3 GND Pin 4 do not connect 4 (BiSS-C CLK)
1…128, 256, 512, 1024 50, 100, 150, 200, 250, 300 10-pin 1.27 mm multipoint connector e.g. Samtec FFSD series Pin 1 do not connect 4 (BiSS-C Data) Pin 2 V CC Pin 3 GND Pin 4 do not connect 4 (BiSS-C CLK) Pin 5 H1 Pin 6 channel A Pin 7 H2 Pin 8 channel B Pin 9 H3 Pin 10 channel I Output signal: CMOS compatible Output current per channel: + 20 mA Adapter Micromotor (Art.-No. 498157) required for all maxon controllers. EASY incremental, commutation signal
Pin 5 channel A Pin 6 channel A Pin 7 channel B Pin 8 channel B Pin 9 channel I Pin 10 channel I
2 1
2 1
9
9 10
10
Output signal: EIA-Standard RS 422 Output current per channel: ± 20 mA
Configuration Counts per turn¹ Cable length
1…128, 256, 512, 1024 50, 100, 150, 200, 250, 300 EASY incremental differential
mm
Cable insulation² Alignment of cable outlet in relation to motor flange ° axial
PVC/PO/FEP
PVC/PO/FEP
axial
EC motor ECX SPEED 8 M modular system
Page Dimensions standard version
M 1:1 Notes
¹ maxon controllers require a resolution of at least 16 counts per turn and commutation signals. ² For PVC-cable (-20 … 100°C) For PO- and FEP cable (-40 … 100°C) ³ H1, index and angle zero are aligned with angle commutation zero (see p. 64). 4 Applying voltage to these pins may destroy the encoder. 5 The max. possible speed depends on the selected counts per turn.
195–196
Further technical details can be found in the product information in the online shop under Downloads.
maxon sensor 509
© 2024 maxon. All rights reserved. August edition. Subject to change.
Made with FlippingBook Publishing Software