ENX 16 EASY Absolute Encoder ∅ 16 mm, 4096 steps, Single Turn
Key data
EASY absolute
Steps per turn Resolution (bit single turn) Encoder length L¹ Ambient temperature
4096 12 8.5 –40…+100 7
mm °C
Weight
g
Selection criteria
EASY absolute
Speed and rotation direction detection Speed and position control Compact and robust design
High resolution Cost effective
suitable
suitable to a limited extent
not suitable
Specifications Supply voltage V CC Typical current draw Max. Speed
EASY absolute
V
5 ±0.5 17 25 000
mA rpm
Connector
10-pin 2.54 mm multipoint connector (IEC/EN 60603-13 / DIN41651) Pin 1 Data Pin 2 V CC Pin 5 do not connect 2 (A) Pin 6 do not connect 2 (A) Pin 7 do not connect 2 (B) Pin 8 do not connect 2 (B) Pin 9 do not connect 2 (I) Pin 10 do not connect 2 (I) Output signal: CMOS compatible Output current per channel +20 mA Pin 3 GND Pin 4 CLK
1
9
2
10
Variants Part Number Signal protocol Cable length
For configurable units depending on configuration
488783 488782 BiSS-C SSI 300 300 Non-configurable units
BiSS-C, SSI
15 mm Alignment of cable outlet in relation to motor flange ° (pitch)
50, 100, 150, 200, 300, 500, 1000
0
0
Modular system
Page Dimensions standard version
M 1:1 Notes
DC motor DCX 16 S DCX 16 L DCX 19 S DCX 22 S DCX 22 L DCX 26 L DCX 32 L DCX 35 L
EC motor
Adapter EASY Absolute 488167 (required for all max- on controllers). 1 Length given excludes any intermediate plate for mounting on a motor. The effective total length of a motor-encoder combination can be found on the respective dimensional drawing. 2 Applying voltage to these pins may destroy the encoder.
105–106 EC-max 16 107–108 EC-max 22 109–110 EC-max 30 111–112 EC-max 40
279/281 282–283 284–285 286–287 302–305 306–311 312–315
113–114 EC-4pole 22 291–292 115–116 EC-4pole 30 293/295
117 EC-i 30 118 EC-i 40
DC-max 26 S 125–126 EC-i 52
ECX PRIME 16 M ECX PRIME 16 L ECX PRIME 22 L
236 237 239
Further technical details can be found in the product information in the online shop under Downloads.
maxon sensor 511
© 2025 maxon. All rights reserved. February edition. Subject to change.
Made with FlippingBook Publishing Software