Brake AB 32 24 VDC, 0.4 Nm
Important information • Permanent magnet – single-face brake for DC (dry operation). Braking in unpowered condition. • Holding brake, prevents rotation of the shaft at standstill or with turned off motor power. • Not suitable for dynamic braking. • It is possible to lower the voltage applied to the brake after it has been energized, for the purpose of reducing heat loss.
Stock program Standard program Special program (on request)
Part numbers
392335
Type
overall length
overall length
Modular system + Motor
Page + Gearhead
+ Sensor Page
Page
Overall length [mm] / • see Gearhead
EC 40, 170 W 272
122.7
EC 40, 170 W 272 GP 42, 3 - 15 Nm 439–441 EC 40, 170 W 272 GP 52, 4 - 30 Nm 443–444
• • • •
EC 40, 170 W 272
HED_5540 536/538
141.1
EC 40, 170 W 272 GP 42, 3 - 15 Nm 439–440 HED_5540 536/538 EC 40, 170 W 272 GP 52, 4 - 30 Nm 443–444 HED_5540 536/538
Technical data Holding torque Mass inertia Max. speed
Pin allocation
24 VDC ±10% Cable (AWG 24) R20 = 100 Ω ±7% red
Designation U Brake + 24 VDC U Brake GND
0.4 Nm Nominal voltage, smoothed
19 gcm2 Resistance 10 000 rpm Duty cycle
100% blue
– Coupling – Opening
≤ 13 ms
Weight
0.1 kg Reaction time
≤ 24 ms Min. cable length
350 mm
Ambient temperature range
-40…+100°C
maxon accessories 589
© 2025 maxon. All rights reserved. February edition. Subject to change.
Made with FlippingBook Publishing Software