Assembly Instructions (Page 2) Tree of Lights
www.ChristmasDesigners.com
6
Lay the light lines in straight rows on the ground prior to installation, ensuring that they are detangled. Lines are labeled 1 to 12, and it does not matter what order you install the lines. Begin adding the light line to the attachment ring with the carabiner. Keeping the lines straight and uncrossed, clip the bottom carabiner into the bottom L-bracket.
7
After light lines are installed, tip the tree upright by walking up the pole slowly, paying attention to the weight of the base. Using stakes or sand bags for weight, secure the base of the tree to the ground.
Stakes
Sandbags
8
For the tree wiring, each line is labeled with a number (1 to 12) and a letter (F for Female, M for Male). Daisy-chain 6 of the lines together, making sure to plug each numbered male line into a different numbered female line. Once 6 lines (half the tree) are daisy-chained together, plug these into an extension cord. Next, daisy-chain the second half of the tree together and run a second extension cord. *Note : do not daisy-chain all 12 lines together.
Do not plug the line into itself (with the same number).
Each male connects to a different female plug number.
9
Loosen the bolts at the base of the tree. Tighten the threaded rod, raising the tree pole and tighten the light strands. Re- tighten the bolts at the base of the tree.
10
Plug your tree in and enjoy the show!
242 | ChristmasDesigners.com
Page 2 of 2
Made with FlippingBook Digital Publishing Software