Power On & Battery Operation
There is no switch to turn on the LTTunit. Just press a key and the unit will power on. When the unit has not been used for a designated time frame it will enter "Sleep Mode" if the Sleep Mode has not been disabled. The unit features a processor that checks to see if a key pressed while it is in the Sleep Mode. There is no significant drain on the batteries. Note: Units with operating software Version K and beyond, the LTTcan be shut-off by holding the Enter key for 7 seconds. The LTT is powered using the high capacity Li-Ion batteries for a long battery life. The battery pack should last up to 30 hours with normal use and 16 hours with a brushless transducer with a maximum charge. The battery icon is always on the display. It is filled in completely when fully charged and shows white space as the battery depletes.
Installation of LTT “Mountz Torque Meter Interface Software”
The interface software allows the operator to conduct Tool Tests, Sensor Calibration and Meter calibration.
1. Insert the CD into the PC and the LTTInterface Program splash screen will appear. Click on "Install LTTProgram". 2. Enter the required information and click Next Button.
2.
1.
3. Click install. 4. After the installation is successful just click Finish.
4.
3.
Page 18
Corporate Headquarters: 1080 North 11th Street, San Jose, CA95112 Phone: (408) 292-2214 Fax: (408) 292-2733 www.mountztorque.com
Made with FlippingBook Annual report maker