Mode Selections
Track
With a torque sensor, this mode constantly tracks increasing or decreas- ing torque variations. Use this mode to monitor varying torque on motors and machinery. Also for calibration and testing of dial torque products (small wrenches or dial screwdrivers).
Track
1500 Hz +00.000 lbf.in
Menu
Tool Tests
Also used for force & load applications with a force sensor.
Peak
With a torque sensor, the display retains the highest torque applied. Use this mode during calibration or testing of any hand type torque wrench (dial, beam, and screwdriver), as well as power tools.
Peak
1500 Hz + 25.010 lbf.in
Also used for force & load applications with a force sensor.
Menu
Tool Tests
First Peak
The display holds the first detected torque peak applied. Before any torque is applied, the display show dashes in the torque value area. Once peak is detected, the display will show the torque value. If a second peak is detected then it will be displayed in the lower right (in small reverse video). This function is primarily used for testing and calibrating click type mechanical torque wrenches. The LTT captures the point where the wrench clicks. This peak may be used for operator training on correct use of the wrench. Always apply torque smoothly to avoid false first peak readings. See page 13 for setting up First Peak.
FPK
3000 Hz ------- lbf.in
Menu
Tool Tests
FPK
3000 Hz 5.4373 lbf.in +7.6261
Not applicable for Force & Load Sensors.
Menu
Tool Tests
Audit
This mode is used to determine “first movement” or what is commonly known as “break-away” torque to determine the actual torque on the joint. An angle enabled transducer is required to operate in this mode. See page 11 for setting up Angle Threshold.
Audit
1500 Hz 10.510 lbf.in
Menu
Tool Tests
0.00
Not applicable for Force & Load Sensors.
Page 8
Corporate Headquarters: 1080 North 11th Street, San Jose, CA95112 Phone: (408) 292-2214 Fax: (408) 292-2733 www.mountztorque.com
Made with FlippingBook Annual report maker