diy furniture
Attach the legs to the short 22.5” apron boards first (right). Using the Kreg Jig , drill pocket holes at each end of the board to connect the legs and four-five sets of evenly spaced holes that will later connect the apron to the table. Apply glue to the ends that will be attached to the table leg. Create proper spacing
Turn them face down and drill holes with a Kreg Jig (above left), about 12” apart, along one edge of each board. Attach all six boards to- gether using pocket screws (above top right). Measure the total width and cut breadboard ends, attach with pocket screws. The table top is then complete.
between the apron, and leg by using a scrap piece of 1” thick wood under the apron and at- tach the apron to the leg with pocket screws.
VintageKC / Fall 2012 11
Made with FlippingBook flipbook maker