Coatings
GSP-0111-E/B
Cleaning criteria 1 – regular maintenance: this involves regular supervision and occasional cleaning (frequency from one to several years according to the use of the facility) using non-aggressive methods and resources (no pressure washing). 2 – non-aggressive cleaning (usually on monthly basis): cleaning performed with neutral products at temperature of < 30°C 86°F and low pressure spraying of ≤ 0.3Mpa 6 266 lbf/sq.ft . 3 – intensive cleaning (usually on daily basis): cleaning performed with neutral products (ph 5 to 9) at temperature of <40°C 104°F and pressure of 3.5 Mpa 73 099 lbf/sq.ft (pressure of spray nozzle). 4 – very intensive cleaning (usually on daily basis): cleaning performed with occasional use of extreme pH (<5 or >9) and/or high temperature (<60°C 140°F ) and/or high pressure washing (pressure <5Mpa 104 430 lbf/sq.ft at output from nozzle and impact pressure <0.04Mpa 835 lbf/sq.ft ). Humidity criteria 1 – humidity ambient conditions: ambient conditions are said to be «humid» where the hygrometry of the facility is high and if under the operating conditions of the facility there is a risk of condensation. 2 – very humid ambient conditions: ambient conditions are said to be very humid where the hygrometry of the facility is very high and if under the operating conditions of the facility the risk of condensation is frequent. 3 – saturated ambient conditions: ambient conditions are said to be saturated where the hygrometry of the facility is very high and if there is a permanent risk of condensation in the operating conditions of the premises.
Outdoor atmosphere
Outdoor atmospheres are classified by categories in order to comply with NF P 34-301 specifications for the selection of panel facings.
Rural or no polluted atmosphere III
Urban or industrial atmosphere
Marine atmosphere
Specific atmosphere
10 to 3 km 6.22 to 1.87 mi IV
< 3 km 1.87 mi V
mixte
high UV
special
normal III
harsh
20 to 10 km 12.43 to 6.22 mi III
Galvanized or coated with alloy (zinc and aluminium) steel Polyester 25 μm 1mil ● ● ● ● ●
● ●
-
-
-
-
●
● ●
● ●
●
● ●
● ●
-
-
-
●
PVDF 35 μm 1.3mil
-
unsuitable
●
consult maker
● ● suitable N.B.: the PET and PVC system are unsuitable for exterior use.
Technical characteristics of the supports
- z225 hot-galvanized pre-powder coated or lined steel sheet , mini shade s280 GD+Z, according to standard NF EN 10326, thickness 0,50 mm 0.019’’ , 0,63 mm 0.024’’ or 0,75 mm 0.029’’ - Stainless steel sheet shades, thickness 0,60 mm 0.023’’ or 0,80 mm 0.031’’ * x5CrNi 18-10 (EN 1-4301 or AISI 304) * x2CrNiMo17-12-2 (EN 1-4404 or AISI 316L) - Pre-powder coated aluminium shade EN AW.3004 H46 according to standard EN 1396, thickness 0,67 mm 0.026’’
11-07-2019
Non contractual document - Dagard reserves the right to modify its products without notice.
-2-
DAGARD - Route du Stade - 23600 Boussac - FRANCE
info@dagard.com - www.dagard.com
80
Made with FlippingBook - professional solution for displaying marketing and sales documents online