This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: techsupport@jgelectronics.com
Tel: 011 789 6033
Web: www.jgelectronics.com How to Youtube Chanel Videos: (5) JG Electronics - YouTube _______________________________________________________________________________________
Instructions for: Polymer Utensil Set
Pressing in the flat heat press:
1. You will need to use the small Muggit red rubber pad to press the Utensil set. (You can find this at JG Electronics)
2. Pre-heat the flat press to 190°C and 90 seconds. Medium-high pressure.
3. Place the Small Muggit silicone pad on top of the press base rubber inside the press and heat up for 30 seconds.
4. Print your design in mirror image on a sublimation printer with sublimation ink and paper.
5. Secure the print facing down, to the bottom bigger area of the utensil, with heat tape.
6. Put only the back end of the untensil with the print in the press (the print needs to be on top).
7. Place the heated small silicone pad over the print of the utensil and close the press on top of it (the front end of the utensil should stick out of the press).
8. REMEMBER TO USE GLOVES AS THE PAD IS HOT!!
9. Press for 90 seconds with Medium to high pressure.
10. Only press 1 side of the utensil at a time.
11. When time is up, immediately remove the print.
OR
Use a Heat shrink bag to press in the oven
1. Print your design in mirror image on a sublimation printer with sublimation ink and paper.
2. Secure the print facing down, to the bottom bigger area of the utensil, with heat tape.
3. Set the Craft oven to 200°C and 5min.
4. Put the utensil with print in the Heat shrink bag and shrink with a heat gun.
5. Bake in the oven for 5 minutes and remove the print and shrink wrap when done baking. Use a heat-resistant glove.
Page 1 Page 2Made with FlippingBook - professional solution for displaying marketing and sales documents online