This is an interactive catalogue showcasing all our printing solutions offered to you. Click the links and videos within the catalogue for more information.
Email: techsupport@jgelectronics.com
Tel: 011 789 6033
Web: www.jgelectronics.com How to Youtube Chanel Videos: (5) JG Electronics - YouTube _______________________________________________________________________________________
Instructions for: Pet Bowl Polymer
1. You will press the pet bowls in the Craft oven with heat shrink bags.
2. Set the oven to 180°C and 7 minutes.
3. Use the template for the bowls to create your artwork. Print your design in mirror image on
a Sublimation printer and with sublimation ink and paper.
4. Let the print face the bowl. Secure the print around the bowl with small pieces of heat
tape, then put one long strip of heat tape all around the bowl over the print.
5. Open the heat shrink bag on the long edge side as well, so that both ends are open.
6. Put the heat shrink bag over the bowl, make sure the open edges of the bag are at the top
and bottom of the bowl, the bowl needs to be centered in the middle of the bag.
7. Use a heat gun to shrink the heat-shrink bag smoothly all around the bowl. Make sure the
shrink bag is pulling tight all over the bowl, covering the printed areas completely.
8. Do not burn any holes in the shrink bag, move the heat gun around when you shrink the
bag.
9. Place in the oven upside down for 180°C and 7 minutes.
10. When time is up, remove the oven tray with the bowl on top, do not remove the bowl from
the tray, and do not remove the print and shrink plastic yet. Because the polymer is still soft
and bendable.
11. Let the bowl cool down completely, then remove the shrink bag and print
12. PLEASE NOTE: If the bowl starts to warp a bit after you take it out of the oven, then while it is
still hot, press the sides that warp softly back into place with oven gloves or any hand
protection.
Page 1 Page 2Made with FlippingBook - professional solution for displaying marketing and sales documents online