TREX HIDEAWAY ® ONE STEP HIDDEN FASTENER TOOL INSTRUCTIONS/ CONT INUED Note: See instructions included with Trex Hideaway Universal Hidden Fasteners for general rules including clean cutting board ends, gapping rules, abutted board rules and installation of angled deck boards, as well as start clip instructions, steps to take for large temperature shifts and installation of last deck board.
INSTALLING TREX SIGNATURE ® D E C K I N G Note : These instructions should be followed when NOT using the One-Step Tool.
2
1
Installation Instructions
3
1
1/4" >40°F* 1/2" <40°F*
2
2
*6mm >4˚C 13mm <4˚C
3
4
2
3. U sing bit included with one-step tool, install screw as shown. Screw should be slightly countersunk into fastener when installed correctly. Continue to install fasteners on every joist. Do Not Overdrive Screw. NOTE: Signs of overtightening would be the tool getting stuck and unable to remove properly and/or signs that the shaft of the bit is damaging the conical screw guide.
1. P lace Hideaway hidden fastener into one-step tool. There will be a slight click when fastener is engaged properly. Screw will also be slightly at an angle when engaged in one-step tool properly.
3
2
NOTE: Use scrap piece of decking to help hold fastener in place while attaching.
4
6
5
2. Center one-step tool (with fastener included) on joist and push into groove of board.
3
4. Install next board against installed hidden fasteners. Some slight force (using a rubber mallet) to seat next board against fasteners may be required.
7
8
17
16
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - professional solution for displaying marketing and sales documents online