North American Fluid Control System Installation Recommendations
Sheet 9522-1
The
symbol is used to call attention to vital safety precautions.
• RECEIPT and INSPECTION: The Fluid Control System is supplied as one unit. Immediately upon receipt of the equipment, and prior to completely uncrating, inspect the equipment for any damage that may have been sustained during shipment.
Shipping damage is not the responsibility of Fives North American Combustion, Inc. Any claims for shipping damage should be made directly for the freight carrier
WARNING: It is imperative that all piping and wiring follow National, State, and Local Codes and Regulations pertaining to the installation of the equipment. Failure to do so may result in personal injury and /or property damage. Installation should be performed by qualified personnel only.
• LOCATION: Install the fluid control system in a location where all devices are accessible. Locate in an area where ambient temperatures do not exceed the ratings of the system components and materials. Locate the fluid control system the closest practical proximity to the combustion system in order to keep interconnecting pipe runs to a minimum.
The fuel gas system should be located on a firm, level, vibration-free foundation
• HANDLING: Using adequately rated slings, spreader bars, chains, etc., carefully lift and set the system in the desired location.
NOTE : The installation and anchoring design of the Fluid System is not the responsibility of Fives North American Combustion, Inc.
• ANCHORING: Anchor the equipment rack to the floor per owner's installation specifications.
CAUTION Particles and debris inside piping can damage equipment components.
NOTE: Insure that all interconnecting pipe lines have been pressure tested and cleaned.
Made with FlippingBook flipbook maker