Installation | Overtemperature Switch
INSTALLATION
Panel Mount Version (8752C-DB)
Unit plugs directly into a panel mount edge connector (supplied with the unit). The captive mounting screws should be tightened into the baseplate after installation to secure unit. All wiring is done to this edge connector, as shown in Figure 1. L1 and L2 are connected to the corresponding terminals. Earth ground must be connected to the terminal labeled GND .
The following terminals are jumpered internally.* 1-2 11-12 3-4 13-14 5-6 15-16 7-8 17-18 9-10
Note: Units with serial numbers below 0800HO do not have internal jumpers. Connections should be made to even numbered terminals only. There is no connection to the odd numbered terminals .
Figure 1. 8752C-DB Wiring
* Internal jumpers will be interrupted if device is removed from mounting base.
Dimensions inches
Figure 2. 8752C-DB Dimensions
Bulletin 8752C Page 3
DIMENSIONS SHOWN ARE SUBJECT TO CHANGE. PLEASE OBTAIN CERTIFIED PRINTS FROM FIVES NORTH AMERICAN COMBUSTION, INC. IF SPACE LIMITATIONS OR OTHER CONSIDERATIONS MAKE EXACT DIMENSION(S) CRITICAL .
Made with FlippingBook flipbook maker