AW23_RSA Unitary Book Complete.indd

3. Take top right corner of graphic and insert rubber edging into corner of frame – ensuring rubber edging is touching the corner of the frame (as per #2) Only insert the corner of the graphic at this stage

Before You Start: - Please make sure 2 people install the graphic, this will avoid the fabric accidentally touching the floo - Please wear white/disposable gloves to reduce the chance of dirt and dust touc ure rubber edging is ner of the frame, there t be any gap left Light Box Fitting Guide Revi

Light Box Fitting Guide Before You Start:

3. Take top right corner of graphic and insert rubber edging into corner of frame – ensuring rubber edging is touching the corner of the frame (as per #2). Only insert the corner of the graphic at this stage.

3. Ta insert – ens c Only

ber edging as ge as possible

Please make sure 2 people install the graphic, this will avoid the fabric accidentally touching the floor where it can pick up dirt and dust. Please wear white/disposable gloves to reduce the chance of dirt and dust touching the fabric. 1. Insert rubber edging from graphic into top left corner – insert approx 20-30cm only, do not install entire top edge of graphic yet 1. Insert rubber edging from graphic into top left corner – insert approx 20-30cm only, do not install entire top edge of graphic yet.

2. Always ensure rubber edging is touching the corner of the frame, there should not be any gap left

Place rubber edging as close to edge as possible 4. Take bottom left corner of graphic and insert 20-30cms into corner of frame – again ensuring rubber edging is touching the corner of the frame (as per #2) Only insert the corner of the graphic at this stage

RRECT

CORRECT

dging is too far e, will creating ng in fabric

Rubber edging is too far from edge, will creating bunching in fabric 4. Take bottom left corner of graphic and insert 20-30cm into corner of frame – again ensuring rubber edging is touching the corner of the frame (as per #2). O nly insert the corner of the graphic at this stage.

2. Always ensure rubber edging is touching the corner of the frame, there should not be any gap left.

CORRECT

INCORRECT

INCORRECT

Place rubber edging as close to edge as possible.

Rubber edging is too far from edge, will creating bunching in fabric.

ORRECT

Made with FlippingBook Digital Proposal Creator