CARE AND MAINTENANCE
Continuous use of cartridges when the filter has reached their capacity, will hinder protection. Gases and vapours can pass immediately to lungs, and from there, they can be absorbed into your bloodstream, causing internal damage. Particulate filters will keep removing contaminants, but will become harder to breathe through, increasing discomfort. Dusts, fumes and mists can irritate the nose, throat and upper respiratory system. Some particulates, depending on their size and type, can pass through to your lungs, where they can damage tissue and increase chances of a more serious health hazard. WHY CHANGE YOUR CARTRIDGE AND FILTERS?
ALL RESPIRATORY PROTECTION EQUIPMENT NEEDS TO BE IN GOOD CONDITION TO WORK SAFELY AND EFFECTIVELY. CORRECT CLEANING AND MAINTENANCE OF RESPIRATORS IS AN IMPORTANT AREA THAT IS COMMONLY OVERLOOKED. After using a respirator, you should clean and inspect it. Be sure to look for: cracks, chips or holes in the breathing tube or airlines, worn or frayed straps; worn or damaged fittings, bent or corroded buckles, or improperly seated valves. If you notice any of these abnormalities, have it repaired or replaced immediately.
QUICK GUIDE FOR CLEANING REUSABLE RESPIRATORS
Remove cartridges or filters STEP 1
Disassemble and immerse the respirator in warm water less than 50°C. You may also use a neutral detergent. STEP 2
Wipe or scrub with a soft brush until clean. STEP 3
If required, disinfect the respirator by soaking in household bleach for two minutes (30ml of bleach in 7.5L of water). STEP 4
Rinse in fresh warm water and air dry in a clean area. STEP 5
Check the respirator components prior to reassembly. A respirator with any damaged or deteriorated components must be repaired or discarded. STEP 6 Store the respirator and cartridges or filters in an airtight container to avoid further moisture and contaminant exposure. STEP 7
5
6 | BUNZL SAFETY | SAFETY PRODUCTS CATALOGUE VOL1
Made with FlippingBook flipbook maker