Calibrations
6 Put the black calibration box on the sensor area (below the square side) and push the rubber by applying force with your finger. Tap Next and keep pushing the rubber with your finger until you see the success message. • The black calibration box must be prepared before you start. • The bottom side of the rubber that is shaped like a square should be located on the square guide line
7 Put the 3D fingerprint dummy rubber on the sensor area (below the square side) and push the rubber by applying force with your finger. Tap Next and keep pushing the rubber with your finger until you see the success message. • The 3D fingerprint dummy rubber must be prepared before you start. • The bottom side of the rubber that is shaped like a square should be located on the square guide line. (Do not place the pattern horizontally on the 3D fingerprint dummy rubber.)
33
Made with FlippingBook interactive PDF creator