2. INTRODUCTION
2.1 AMTECH AutoVent collectors ( AV’s ) are compactly designed and usually installed with a welding cell, to improve the air quality in a relatively, confined space, and at the same time inhibit welding smoke/fumes and dust from degrading the air quality in a larger area (such as the plant). The collectors for the AV ’s come in a 4, 6, 9, and 12 cartridge size, with a corresponding air flow rate of 2500, 4000, 6000, and 8000 cfm, respectively. A properly configured AV and welding cell can provide a relatively safe work station; however, given the combustible nature of welding fume/smoke and the inherent generation of sparks from grinding, prudent operation of the system and periodic maintenance is essential. Spark baffles and spark mesh are offered as an option on these units and are STRONGLY recommended. The collector is designed to be mounted in a variety of fashions including: suspension from the roof structure (provided the building structure is of adequate design), supported by legs, or placed directly on the floor. A dust drawer is available for floor mounted installations and for suspended or leg supported installations a hopper is available to facilitate the collection/removal of dust. The collector unit is positioned appropriately • The welding cell or other containment area (and curtain, if equipped) is assembled and connected to the collector • Electrical power is connected (appropriately) • Fire detection/suppression systems connected (appropriately – and if so equipped). • Compressed air is connected (appropriately) 2.2 Installation is complete after: • 2.3 MOST FILTERING MEDIA IS COMBUSTIBLE EVEN WHEN IT IS TREATED WITH FLAME RETARTANT MATERIALS. PRECAUTIONS SHOULD BE TAKEN TO PREVENT BURNING MATERIAL FROM COMING INTO CONTACT WITH THE FILTERING MEDIA. 2.4 FIRE OR SMOKE DETECTION DEVICES AND APPROPRIATE EXTINGUISHING SYSTEMS MAY BE REQUIRED DEPENDING ON LOCAL CODES AND AUTHORITIES. PLEASE VERIFY WITH THE APPROPRIATE AGENCIES WHICH MAY INCLUDE, BUT MAY NOT BE LIMITED TO THE FIRE DEPARTMENT, YOUR INSURANCE COMPANY AND LOCAL, STATE OR FEDERAL AUTHORITIES. SHOULD YOU HAVE ANY QUESTIONS, PLEASE CONTACT THE MANUFACTURER OR HER/HIS REPRESENTATIVE PRIOR TO OPERATING THE EQUIPMENT. 2.5 It is imperative that the equipment be verified, cleaned and properly maintained on a continual basis to ensure proper and safe operation. This maintenance can usually be performed on a contract basis if necessary. Contact your Distributor for details. 2.6 All employees should be familiar with the on/off controls. No burning, torches or cutting should be carried out in direct proximity to the unit. Where welding, cutting or grinding being performed, a suitable fire extinguisher(s) should be accessible.
2.7 Good judgment should be utilized at all times. If you are unsure about the system components or function, please contact your Distributor.
2.8 THINK SAFETY FIRST!
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Online newsletter maker