7.1.3 After the installation, access/clearance must be available to service the following
components:
1. Filters/Baffles 2. Fan/Motor 3. Valves 4. Controls 5. Dust drawer or hopper
7.2 Mechanical
NOTE: All of the mechanical installation must be performed by a qualified installer and in accordance with local, state, and national codes/regulations/laws (if any).
7.2.1 The AutoVent Collector is usually coupled to a welding cell. Placement/movement of the unit inside the factory/building is usually a major concern. Ensure you have enough room in front of the access doors and/or dust drawers for easy filter access, as well as, all around the unit for access in the event of maintenance or emergency.
7.2.2 Check with your building architect/engineer to determine if placement is appropriate, especially if the unit is being suspended by an overhead structure.
7.2.3 After placement, the collector should be properly secured to the floor using tapered anchor bolts or properly secured to an overhead structure. CONSULT YOUR BUILDING ARCHITECT/ENGINEER.
NOTE: Should questions arise concerning total weight, consult your CLEAN AIR INDUSTRIES Distributor or CLEAN AIR INDUSTRIES Factory. 7.3 Electrical
NOTE: All of the electrical installation must be performed by a qualified electrician and in accordance with local, state, and national codes/regulations/laws (if any).
7.3.1 The blower motor is typically configured to operate with 208-230/460 volt, 60 cycles, and 3 phase electrical power, unless specified otherwise with the equipment order. The electrical connections to the blower (and wiring) must be sized and selected in accordance with local, state, and national codes. 7.3.2 The blower is designed to rotate clock wise when viewed from the motor side (top of blower). If the blower is running in reverse, the air volume will be approximately 50% of the designed air volume and excessive noise will be generated. Therefore, once the motor is wired, check motor rotation by energizing the blower motor for a brief instant (“JOG”). If direction is reversed, then correct. Switching two (2) of the 3-phase connections on the output side will reverse the direction of rotation.
7.3.3 Your unit is equipped with the “ Turbo Digital Pulse Control ” , this feature will need to be connected to a 115 volt power source. Power consumption is less than 50 Watts.
7.3.4 If your unit is equipped with any optional electrical features, then these will need to be connected to the appropriate power source.
NOTE: Instructions that detail the operation of Turbo Digital Pulse Control is available under separate cover. A copy of the instructions should have been supplied with the unit.
sales@clean-air.com
1-866-665-1829
www.clean-air.com
Made with FlippingBook Online newsletter maker