FGA v2a Operation Manual

Torque Setting Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn the knob clockwise to increase torque and counterclockwise to decrease torque. After selecting your torque value, release the locking bar slide, and it will return to its original position. Per ISO:6789-1, when certified, the tool is adjusted from the bottom-up.

Note: Do not adjust torque above or below the designated torque ranges for the torque screwdriver. If you exceed the upper torque range capacity of the screwdriver, the tool's screen will display the letter "H." If you exceed the lower torque range capacity of the screwdriver, the tool's screen will display the letter "L."

Torque Setting Increments

The screwdriver's torque settings are selectable in increments.

FGA-8

FGA-20

Units

Increments

Units

Increments

ozf.in

0.5

ozf.in

1

(Settings < 5 lbf.in) 0.05 (Settings > 5 lbf.in) 0.1

lbf.in

0.02

lbf.in

cN.m

0.5

cN.m

1

N.m

0.005

N.m

0.01

kgf.cm

0.05

kgf.cm

0.1

FGA-40

FGA-80

Units

Increments

Units

Increments

ozf.in

2.5

ozf.in

-------

(Settings < 40 lbf.in) 0.5 (Settings > 40 lbf.in) 1.0

0.1

lbf.in

lbf.in

cN.m

2

cN.m

-------

(Settings < 2 N.m) 0.02 (Settings > 2 N.m) 0.05 (Settings < 45 kgf.cm) 0.5 (Settings > 45 kgf.cm) 1.0

N.m

0.02

N.m

kgf.cm

0.2

kgf.cm

Applying Torque 1. Tighten the fastener or bolt by applying a steady twist. Keep the screwdriver in line with the axis of the bolt during tightening. The screwdriver will ‘slip’ after achieving the pre-set torque setting.

SILICON VALLEY HEADQUARTERS 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com

2

Made with FlippingBook Annual report maker