EZ-TorQ III Manual
6. Set Up
6.1. Setting
No
Item
Description
Target torque can be selected by the UP and DOWN arrow. Touch the target target torque to open the numeric key pad. Target torque can be selected by the UP and DOWN arrow. Touch the center of
1
Up/Down &Numeric key pad
2
Target Torque & Tolerance
Check Check on/off to apply the target torque and tolerance settings s.
Select manually clear data
Select amount of time (seconds) to clear the test data display
) to clear the test data displayed. Or disable to
3
Auto clear (sec)
4
Torque Units
ozf.in. / lbf.in / ozf.in. / lbf.in / lbf.ft / vN.m / N.m / kgf.m / kgf.cm
5
Mode
Peak torque, Track torque or First Peak torque, Track torque or First-peak torque
6
LPF (Low Pass Filter) freq
LPF (Low Pass Filter) LPF (Low Pass Filter) frequency setting. ISO standard is 500Hz ISO standard is 500Hz
7
Direction
Rotation direction Rotation direction selection Clockwise, Counterclockwise or Both direction Both directions
You can enter the serial number of the tool you want to measure. This serial number is stored on the SD card along with the This serial number is stored on the SD card along with the test test data
8
Tool SN
Tech Support: (669) 200-4219 www.mountztorque.com
11
Made with FlippingBook Annual report maker