HOW TO INSTALL HORIZONTAL SWIVEL RAILING/ CONTINUED TREX SIGNATURE ® STANDARD
Cutting Top Rail Option 1: For Post-to-Post Configuration
Cutting Top Rail Insert and Cover
6
KEY Mark Cut
KEY
5a
Top rail
Top rail
3/4" (1.9 cm)
3/4" (1.9 cm)
1/4" (0.6 cm)
1/4" (0.6 cm)
6. Slide rail insert out and cut 3/4" (1.9 cm) FROM EACH SIDE of insert, then slide back inside rail and center. 7. Mark and cut top rail
5a. Cut top rail to the measurement between the top swivel brackets. For standard post-to-standard post configurations this would be same dimensions as that of the bottom rail.
7
cover same length as top rail for all top rail configurations.
Top rail
Cutting Top Rail Option 2: For Post-to-Crossover Post Configuration
5b
Standard post
8. Attaching Center Baluster to Bottom Rail See instructions on page 85 Post-to-Post or 93 Post-to- Crossover Post.
Crossover post
9. Attaching Foot Block (when required) See instructions on page 86.
10. Attaching Bottom Rail Cover and Bottom Rail to Brackets See instructions on page 85 Post-to-Post or 93 Post-to- Crossover Post. 11. Installing Remaining Balusters into Bottom Rail See instructions on page 86 Post-to-Post or 94 Post-to- Crossover Post. 12. Attach Upper Railings S ee instructions on page 86 Post-to-Post or 94 Post- to- Crossover Post. 13. Attachment of Bracket Covers, Skirts, and Caps See instructions on page 87 Post-to-Post or 94 Post-to- Crossover Post.
5b. When going from standard-post to crossover post, measurement must be taken from inside of top horizontal swivel bracket to inside lip of crossover bracket (which is attached to top of crossover post).
100
Made with FlippingBook - Online Brochure Maker