ATTACHING STAIR SWIVEL/COMPOUND SWIVEL BRACKETS AND RAILS TO POSTS AND PRESSURE-TREATED POST AND POST SLEEVES/ CONTINUED TREX SIGNATURE®
9
5
2
1
3
5. Attach “flat” bottom stair rail cover to bottom stair rail. Align cover on one side of the bottom rail in slot on side of rail. Then starting from one end of rail snap cover onto opposing slot working down the length of the rail. In some cases, GENTLE tapping with a rubber mallet may facilitate fastening.
9. Position top stair rail onto balusters ensuring balusters are fully seated in top rail (position to side of post) and ENSURE that balusters are parallel with post. Installing Upper Stair Swivel and Compound Swivel Brackets
6. Attaching Foot Block (where recommended) See instructions on page 104.
10
7
1
1
10. Clamp brackets to side of rail with brackets in correct swivel location/angle (this is important to ensure correct location of swivel brackets).
7. Set bottom stair rail into bottom stair rail brackets. Attach bottom stair rail to bottom stair bracket using two self-tapping screws (provided) on each side of bracket. Installing Upper Brackets and Measuring Upper Stair Rail–Stair Swivel and Compound Swivel IMPORTANT NOTE: BEFORE CUTTING ANY TOP RAILS MAKE SURE THAT WHEN MEASURING, ALL BALUSTER HOLES LINE UP PARALLEL!
11
1
8
8. Place two balusters into lower rail at each end closest to post.
2
11. Mark a light line on posts at UNDERSIDE of where swivel bases (positioned correctly) meets the posts.
108
Made with FlippingBook - Online Brochure Maker