HOW TO INSTALL HORIZONTAL CURVED RAILING / CONTINUED TREX SIGNATURE ®
Installing Posts and Swivel Brackets 1. Install posts and horizontal swivel brackets as stated within Trex Signature Post and Horizontal Swivel Bracket Instructions.
4
How to Measure and Cut Bottom and Top Rails
2
4 Place base (smaller side facing down) on decking surface. Pre-drill using a 3/16" bit. Attach base of Foot Block using one screw at an angle through base and into decking.
5
5. After attached, use a rubber mallet along with scrap piece of
wood to tap Foot Block until it locks into place.
2. With brackets in correct swivel location, measure distance from inside of bracket to inside of bracket. BEFORE CUTTING, ENSURE THAT BALUSTER HOLES ON BOTH BOTTOM AND TOP RAIL LINE UP.
Attachment of Foot Block
Installing Lower Rail to Brackets 6. Place adhesive strips
6
3
(provided) into bottom rail brackets, and then place bottom rail into brackets.
2
NOTE: Make sure surface is clean and dry.
1
Installing Balusters into Bottom Rail
2
7
3. Temporarily set bottom rail into bottom brackets, and place Foot Block under bottom rail centered between bottom brackets. Mark to provide placement location of base. Remove bottom rail.
7. Place balusters into holes in lower rail by snapping fully into place.
118
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker