HOW TO INSTALL HORIZONTAL PANELS/ CONTINUED TREX SIGNATURE ®
Cutting Top Rail Option 3: For Crossover Post-to-Crossover Post Configuration
Attaching Foot Block (when required) (One Foot Block is required for all spans over 6')
6
KEY Mark Cut
KEY
3c
Top rail
3/4 " (19 mm)
3/4 " (19 mm)
2
6. Temporarily place panel onto brackets. To ensure correct location, place Foot Block under center of bottom panel rail. Mark to provide placement location of base.
3c. Cut each end of top rail 3/4 " (19 mm) LONGER than the mark to allow for fitting into the crossover post bracket on each side.
7
4
Top rail
3/4 " (19 mm)
3/4 " (19 mm)
7. R emove railing panel and place base (smaller side facing down) on decking surface. Pre-drill using a 3/16" bit. Attach base of Foot Block using one screw at an angle through base and into decking.
4. U sing razor knife or other cutting tool, cut rail insert 3/4 " (19 mm) FROM EACH SIDE .
8
8. A fter attached, use a rubber mallet along with scrap piece of
5
5. M ark and cut top rail cover same length as top rail for all top rail configurations.
Top rail
wood to tap Foot Block until it locks into place.
9
Installing Trex Signature Panel Using Lower Rail Tabless Bracket 9. P eel backings from adhesive strip provided and place inside the bottom bracket.
NOTE: Make sure surface is clean and dry.
123
Made with FlippingBook - Online Brochure Maker