HOW TO INSTALL HORIZONTAL PANELS/ CONTINUED TREX SIGNATURE ®
Attachment of Bracket Covers, Skirts, and Caps
10
14
15
Trex Signature post ™ ®
14.A ttach corresponding bracket covers over opening in upper and bottom rails. 15. A ttach provided post skirt to bottom of posts when using Trex Signature posts.
10. P lace panel in bottom and top brackets.
11
11. For post-to-post
configuration, pre-drill using a 7/64" (0.28 cm) drill bit, and fasten upper
17
16
2
rail to each bracket by installing screws diagonally through
Post sleeve
Trex Signature post ® ™
7/64" (2.8 mm)
upper rail into bracket using two self-tapping screws each side (provided with bracket kit) .
1
12. F or crossover post
12
configuration, fasten upper rail to crossover post by installing screws diagonally through upper rail into post using two self- tapping screws each side (provided with bracket kit) .
16. A ttach post caps to Trex Signature posts (use of rubber mallet may be required for secure attachment). 17. A ttach post caps to post sleeves using external grade PVC construction adhesive (apply adhesive on the inside self-centering/corner tabs).
2
1
7/64" (2.8 mm)
18
18. F or crossover post
configuration, attach crossover post cap to crossover post.
NOTE: Pre-drilling is required. It's best practice to pre-drill a single hole, then attach screw, and continue in this order.
13
13. A ttach upper rail cover to upper rail by aligning cover on one side of rail. Then, starting from one end of rail, snap cover onto opposing slot working down length of rail. GENTLE tapping with a rubber mallet may facilitate fastening.
124
Made with FlippingBook - Online Brochure Maker