HOW TO INSTALL HORIZONTAL PANELS/ CONTINUED TREX SIGNATURE ®
10
14
15
Trex Signature post ™ ®
1
2
Attachment of Bracket Covers, Skirts, and Caps 14. Attach corresponding bracket covers over opening in upper and bottom rails. 15. Attach provided post skirt to bottom of posts when using Trex Signature posts.
10. Place panel in bottom and top brackets.
11
11. For post-to-post
configuration, pre-drill using a 7/64" (0.28 cm) drill bit, and fasten upper
17
16
2
rail to each bracket by installing screws diagonally through
1
2
Post sleeve
Trex Signature post ® ™
7/64" (2.8 mm)
upper rail into bracket using two self-tapping screws each side (provided with bracket kit) .
1
1
12. For crossover post
3
12
configuration, fasten upper rail to crossover post by installing screws diagonally through upper rail into post using two self- tapping screws each side (provided with bracket kit) .
16. Attach post caps to Trex Signature posts (use of rubber mallet may be required for secure attachment). 17. Attach post caps to post sleeves using external grade PVC construction adhesive (apply adhesive on the inside self-centering/corner tabs).
2
1
7/64" (2.8 mm)
18
18. For crossover post
configuration, attach crossover post cap to crossover post.
NOTE: Pre-drilling is required
13
2
1
3
13. Attach upper rail cover to upper rail by aligning cover on one side of rail. Then, starting from one end of rail, snap cover onto opposing slot working down length of rail. GENTLE tapping with a rubber mallet may facilitate fastening.
125
Made with FlippingBook - Online Brochure Maker