HOW TO INSTALL TREX SIGNATURE ® STAIR PANELS/ CONTINUED TREX SIGNATURE ®
5
8
Bottom stair bracket – bottom rail
Top stair bracket – bottom rail
5. P lace base (smaller side facing down) on decking surface. Pre-drill using a 3/16" bit. Attach base of foot block using one screw at an angle through base and into decking.
Top stair bracket – top rail
Bottom stair bracket – top rail
6
6. A fter attached, use a
rubber mallet along with scrap piece of wood to tap foot block until it locks into place.
Attaching Upper and Lower Stair Brackets 8. C enter stair brackets on posts above the marked line and attach using two self-tapping screws (provided). In some cases it may be difficult to attach the stair bracket on the lower stair post. A 90˚cordless drill is recommended to attach screws in this area.
Cutting Stair Panel Rails:
KEY Mark Cut
KEY
7
Attaching Stair Panel to Brackets
9
1/4" (0.6 cm)
1/4" (0.6 cm)
7. Remove panel and place on flat surface. Cut each end of the bottom and top stair rails 1/4" (0.6 cm) shorter than the mark on each end to allow for fit into stair rail brackets. NOTES: » Railing does not need to be cut at angle. Brackets are designed to allow for railing to be installed with standard straight cut.
9. A ttach stair panel to brackets using two self-tapping screws (provided) on each side of stair bracket.
128 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker