HOW TO INSTALL TREX SIGNATURE ® STAIR PANEL USING STAIR SWIVEL/COMPOUND SWIVEL BRACKETS/ CONTINUED TREX SIGNATURE ®
13
14
13. Attach post caps to Trex Signature posts (use of rubber mallet may be required for secure attachment).
14. Attach post caps to post sleeves using external grade PVC
2
Trex Signature ™ post ®
construction adhesive (apply adhesive on the inside self-centering/ corner tabs).
Post sleeve
1
3
ATTACHING CROSSOVER SWIVEL BRACKETS ON SIGNATURE POSTS TREX SIGNATURE ®
1. Follow previous instructions for installation of stair panel using fixed or swivel brackets but DO NOT CUT TOP RAIL. Determining Placement of Stair Crossover Swivel Bracket 2. Insert stair crossover swivel bracket into post. 2
4
1/4" (0.6 cm)
NOTE: Keep the bracket cover on when inserting this into post, this will cover the screw attachment area.
Bracket cover
Attaching Stair Crossover Swivel Bracket to Post 4. Once location/height is determined, center and predrill two holes (using a drill bit slightly smaller than that of self-tapping screw diameter) on opposite sides of post, approximately. 1/4" (0.6 cm) from top of post. Drill through the post and into the stair crossover swivel bracket on each side. NOTE: Slightly countersink pre-drilled holes to allow for flat head screws to seat flush on the post. This will allow cover to fit over screw heads.
3
X°
5
2
3. Determine location/height of the stair crossover swivel bracket by aligning the angle of this with the fixed brackets already installed. Note that the crossover post may need to be cut to ensure the top stair rail is parallel to the bottom stair rail.
5. Attach stair crossover swivel bracket to post with two self-tapping screws (provided). Slide cover over post to hide screws.
132
Made with FlippingBook - Online Brochure Maker