ATTACHING CROSSOVER SWIVEL BRACKETS ON SIGNATURE POSTS TREX SIGNATURE ®
Cutting Top Stair Rail For Stair Post-to-Stair Crossover Post Configuration
7
7. For stair crossover post 7 configuration, fasten upper stair rail to swivel crossover post bracket by installing screws diagonally through crossover stair bracket into upper rail using
KEY Mark Cut
KEY
6
Standard post
Top stair rail
two self-tapping screws (provided) on each side.
Attachment of Brackets 8. See previous instructions based on bracket type installed.
Note: Only showing top rail in this image for clarity. DO NOT ATTEMPT to remove
the top stair rail from the panel.
Bracket Covers, Skirts, and Caps 9. See previous instructions.
Crossover post
1/4" (0.6 cm)
6. Top stair rail must be cut differently on each side of the rail. Railing side that attaches to standard post and if using a fixed bracket, should be cut 1/4" (0.6 cm) shorter than the mark to allow for fit into top rail bracket. Railing side that attaches using a stair swivel bracket should cut on the mark . Railing side that attaches to the crossover post should be cut directly on the mark to allow for fit into the crossover post bracket. NOTE: Railing does not need to be cut at angle. Brackets are designed to allow for railing to be installed with standard straight cut.
133 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker