HOW TO INSTALL HORIZONTAL MESH RAILING/ CONTINUED TREX SIGNATURE ®
Attaching Top Rail to Brackets
25
23
23. Drill two 1/2" holes approximately 1/2" from end of top rail. Repeat this on opposite side of top rail.
25. Install two #8 x 1-1/4" screws provided into top rail and top bracket on each end of top rail.
26
IMPORTANT NOTES: » HOLES CANNOT EXTEND PAST
1/2" (1.3 cm)
BRACKET, OTHERWISE BRACKET COVER WILL NOT COVER HOLES. » ONLY DRILL 1/2" HOLES
Bracket Edge
Post
THRU TOP WALL OF TOP RAIL. DO NOT USE A STEP BIT.
24
26. Cut snap-in channel filler to correct length and install into channels of bottom and top rails. Use of a rubber mallet may assist with this step. DO NOT attempt to cut short snap in pieces with a miter saw. Use an angle grinder or hack saw only.
24. Using 9/64" bit provided, center into above holes and PREDRILL into top rail bracket at a depth of approximately 1-1/4". Use care to not drill through underside of top bracket.
174 NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker