HOW TO INSTALL HORIZONTAL MESH COCKTAIL RAILING/ CONTINUED TREX SIGNATURE ®
3. How to Measure Bottom and Top Rails See instructions on page 169.
17. Installing Snap-in Channel Filler See instructions on page 173.
4. Cutting Rails
NOTE: Top Bracket Covers are not attached in this configuration.
See instructions on page 169.
18
5. Attachment of Foot Block (REQUIRED) See instructions on page 169.
Attaching Deck Board to Top Rail 18. Place deck boards ( DO NOT use Enhance deck boards for top rail)
6. Installing Bottom Rail and Adding Weep Holes to Bottom Rail See instructions on page 170.
over top rails. Attach boards on each post with Trex-recommended composite screws (quantity of 2 per each post/board end).
7. Cutting Mesh (if required) See instructions on page 170.
8. Cutting Bottom PVC Gasket and Installing onto Mesh See instructions on page 170. 9. Centering Mesh and Installing into Bottom Rail See instructions on page 171. 10. Installing Vertical PVC Gaskets onto Mesh See instructions on page 171. 11. Installing L-Brackets into Vertical Supports See instructions on page 171.
19. S ecure boards to top
19
rail using Trex Signature Cocktail Bracket (sold separately). Ensure that there is a bracket at each end of the railing section, then space brackets approximately every 24" and attach with 4 screws provided.
NOTE: Pre-drilling before attachment is recommended.
12. Installing Vertical Supports See instructions on page 172.
20
20.Use scarf cut for posts where two deck boards meet. NOTES: » L eave 1/8" (3 mm) gap between deck boards. » D eck boards can
13. Cutting Top PVC Gasket and Installing onto Mesh See instructions on page 172.
14. Installing Top Rail onto Mesh Panel See instructions on page 172.
15. Attaching L-Brackets to Top and Bottom Rails See Instruction on page 172.
overhang end of last post maximum 1/2" (13 mm).
16. Attaching Top Rail to Brackets See instructions on page 173.
21. Attachment of Bottom Bracket Covers See instructions on page 174.
175
Made with FlippingBook - Online Brochure Maker