HOW TO INSTALL HORIZONTAL CABLE RAIL/ CONTINUED TREX SIGNATURE ® X-SERIES ™
12
12. Tighten screw in locking assem- bly using a 5/32" Allen wrench.
10c
Note: Cables removed from image above for clarity
Fastening Pass-Through Post Bracket to Pass-Through Post (When Required) 13. Install two barrel bolts through Pass- Through Post as 13
10c. For 6' spans (or spans that have 1 top rail), install rail onto both X-Series Anchor Posts.
shown. Insert screw on opposite side and tighten using a 1/8” Allen wrench.
Installing Top Rail Straight Brackets in X-Series Anchor Posts
11a
Threading Push-to-Connect Fittings into Turnbuckles
14
11a. Position the top rail straight bracket PARTIALLY into the X-Series Anchor Post as shown.
11c
11b
11b. Slide the top rail locking assembly onto the dovetail on the top of the bracket.
14. Thread each push-to-connect (PTC) fitting into the turnbuckle on each short cable until the threads just disappear in the turnbuckle. Ensure threads are flush with the end of the turnbuckle.
11c. Slide the bracket down until it sits on the cable infill adapter. Note that the screw in the locking assem- bly may need to be loosened to allow the locking assembly to fit properly in the X-Series Anchor Post.
202
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker