HOW TO INSTALL HORIZONTAL CABLE RAIL/ CONTINUED TREX SIGNATURE ® X-SERIES ™
19
18
11 9 7 5 3 1 2
1
2
4 6 8 10 12
18. Using the turnbuckle wrench(es) provided (one per kit), place one wrench on the flat sides of the PTC fitting. Place a second wrench on the turnbuckle as shown so that it locks in place with the cutouts on the end of the turnbuckle. Note: » An adjustable wrench can also be used on the flat sides of the PTC fitting. » Use the release tool on the turnbuckle wrench to release the cable from the PTC fitting if needed. PTC fittings are intended to be single use after the cable has been tensioned. Do NOT reuse PTC fit- tings after tensioning.
19. Tension each cable to 100 lbs by rotating the turn- buckle-side wrench. Do NOT rotate PTC fitting when tensioning cables. Tension cables from the center outward, following the sequence shown. Repeat sequence as necessary until all cables are fully ten- sioned. Note: 42” rail height (with 12 cables) shown here.
Centering Cable Brace(s)
20
3
1
1
2
20. Locate the center of each span and slide all cable braces to their center positions. Ensure that cable braces are straight/vertical, and then tighten both top and bottom set screws using a 3/32" Allen wrench.
204
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker