HOW TO INSTALL TREX ® WEDGE DECK RAIL LIGHT/ CONTINUED
11
7a
10
6
2
6. Turn post upside down and fish 5 ' male-to-male wire (provided) through hole in baseplate. 7a. If connecting a Wedge Deck Rail Light only, pull wire through hole. TIP: Insert a zip-tie loop (or small grabber tool) through 9/16 " (14 mm) hole. Fish wire through loop in zip-tie. Pull wire through hole with zip-tie.
10. Slide light cover down over backing plate, adjusting mounting screws as necessary to achieve a tight fit. 11. Turn post over and carefully fish wire through hole created in Step 3 to underside of the deck. Ensure exit point of wire under blocking will not be pinched by ALPOSTHWDECK plate. 12. Mount post per instructions.
7b. If connecting a Trex
5' Male-to-Male Wire (from Post Cap)
7b
Signature post cap light as well, and using the 3-way splitter (see note after Step 12), simply run one wire through the hole created in Step 5 to the top of the post.
3-Way Splitter
5' Male-to-Male Wire (from Post Lamp)
5' Male-to-Male Wire (from Baseplate hole)
NOTE: If connecting a Trex Signature post cap light as well, a 3-way adapter and extra 5' male-to-male wire (not provided) can be used inside the post so that only one wire must be run through the hole in the base of the post (and post blocking). This is optional.
9
8
8. Connect male connector to female connector on light housing. 9. Place light and attach backing plate to post with three screws (provided).
21
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker