HOW TO INSTALL STAIR CABLE RAIL TREX SIGNATURE ® X-SERIES ™
Installing Long Cables into Push-to-Connect Fittings and Tensioning Cables
IMPORTANT NOTE: »
If installing X-Series Cable Rail near saltwater environ- ments, spray a small amount of WD-40 Specialist® Corrosion Inhibitor in the open end of the PTC fit- ting before inserting the cable. Do this IMMEDIATELY before inserting the cable to prevent dirt and dust from collecting inside the fitting. Use caution not to get this on the decking surface! Protect decking from drips and runs.
20
19
19. Push the end of each long cable into opposite PTC fitting, slightly rotating the PTC fitting counterclock- wise and cable clockwise (approximately 1/4 turn) until cable is fully seated.
20. Hand-tighten all cables by holding the PTC fitting fixed and rotating the turnbuckle. Do NOT rotate PTC fitting when tightening cables.
214
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker