HOW TO INSTALL STAIR CABLE RAIL TREX SIGNATURE ® X-SERIES ™
22
21
13 11
2
9 7 5 3 1 2
4 6 8 10 12
21. Using the turnbuckle wrench(es) provided (one per kit), place one wrench on the flat sides of the PTC fitting. Place a second wrench on the turnbuckle as shown so that it locks in place with the cutouts on the end of the turnbuckle. Notes: » An adjustable wrench can also be used on the flat sides of the PTC fitting. » Use the release tool on the turnbuckle wrench to release the cable from the PTC fitting if needed. PTC fittings are intended to be single use after the cable has been tensioned. Do NOT reuse PTC fittings after tensioning.
22. Tension each cable to 100 lbs by rotating the turnbuckle-side wrench. Do NOT rotate PTC fitting when tensioning cables. Tension cables from the center outward, following the sequence shown. Repeat sequence as necessary until all cables are fully tensioned.
» NOTE: 42" rail height (with 13 cables) shown here.
215
Made with FlippingBook - Online Brochure Maker