HOW TO INSTALL ALUMINUM GATE
1
5
2
5. Adjust posts so that cut marks do not fall on a baluster. Make sure distance from first baluster to post is the same on both sides. Mark cut locations on panel.
1. Measure opening between posts (gates can be customized to fit nearly any opening up to 48 " [1219 mm] wide). 2. Subtract 1-7/8 " (48 mm) from above measurement. This will allow for proper gapping and location of gate.
NOTE: If widths do fall on a baluster, cut baluster flush at top and bottom prior to cutting panel.
6
3
6. Cut panel using a reciprocating saw (equipped with a metal blade).
3. Identify top and bottom of panel.
7
4
7. Insert posts into panel.
NOTE: The posts only fit in one direction. 4. Lay panel on a flat non-marring surface. Place posts on top of panel. Place posts so that width measurement from Step 2 is to the outside of each post.
NOTE: Make sure top and bottom of panel orientation is correct.
222
NOTE: Construction methods are always improving. Please refer to www.trex.com for the most up-to-date installation requirements.
Made with FlippingBook - Online Brochure Maker